How to solder cable from speaker to subwoofer: Creative A200 2 Speakers

[Gs11]

My Creative 9 pin male din is damaged. I want to solder cable directly to PCB. I have 6 small cables: red,blue,gray,white,orange,black.

 

 

[circeseye]

if you know where each wire goes, just unsolder the plug from the pcb and solder the wires in its place

[Gs11]

the pont is I don't know and MUST  be sure where goes what

 

six wires: white,gray,blue,red,brown +black (probably ground)

where to solder them? I need to make sure that they will be well soldered.

if someone can mark the places of soldering on the enclosed picture - I WILL BE GRATEFUL

 

 

http://obrazki.elektroda.pl/3633460500_1316718193.png

[circeseye]

ok take your plug you cut off.

match the wire in the plug to where it goes on the connector on the pcb. you should be able to see what solder joint it goes to

[Gs11]

12 hours ago, circeseye said:

ok take your plug you cut off.

match the wire in the plug to where it goes on the connector on the pcb. you should be able to see what solder joint it goes to

It won't work, on top side copper PCB there is DIN 9-pin socket, I won't see anything like this. Need to solder out socket and somehow figure it out hot to attach cables to PCB....

[circeseye]

ok didnt see the pic of the plug.....yea you need to unsolder and remove the plug from the pcb.....then carefully remove the casing of the plug so you can see where the pins go to the board. ...then its just soldering each wire where each pin went on the pcb