No Post on GPU.

[MarkDerkach]

Hey everyone,

 

I upgraded my 1070 to an RX6800 very impulsively today after my 1070 died while playing battlefront II.

 

After lots of troubleshooting before purchasing my new GPU. My motherboard ASUS X570 Tuf Gaming Plus (wifi) was displaying the troubleshooting code for VGA. We tried clearing cmos, booting without GPU, switching PCI slots, etc.

 

my system is as follows. R9 3900XT, RX6800 GPU, 32GB Corsair Vengance 3200MHz, ASUS X570 Tuf Gaming Plus (wifi). 

 

We were able to boot once with the new graphics card in place. But now it’s not booting and stuck at the original problem. White VGA light and not finishing the post sequence. 
 

Please heeeelp..

[WhitetailAni]

Did you DDU your NVIDIA drivers before installing your 6800?
If not, put your 1070 back in and DDU your drivers with this guide:

https://www.wagnardsoft.com/content/ddu-guide-tutorial
And then put your 6800 in and install your AMD drivers.

[MarkDerkach]

5 minutes ago, ragnarok0273 said:

Did you DDU your NVIDIA drivers before installing your 6800?
If not, put your 1070 back in and DDU your drivers with this guide:

https://www.wagnardsoft.com/content/ddu-guide-tutorial
And then put your 6800 in and install your AMD drivers.

Not to be rude, but the system doesn’t post. It stopped posting after my initial system shutdown last night while playing battlefront. After hours of troubleshooting we knew the GPU was dead (tried in a spare pc) so we bought a new GPU to see if that would work.

[WhitetailAni]

Just now, MarkDerkach said:

Not to be rude, but the system doesn’t post. It stopped posting after my initial system shutdown last night while playing battlefront. After hours of troubleshooting we knew the GPU was dead (tried in a spare pc) so we bought a new GPU to see if that would work.

Ah.

So the 1070 is dead.

If it doesn't POST with the 6800, remove everything but the CPU, GPU, and 1 stick of RAM. Remove everything else, including your storage drives.