Corsair lighting node pro issues

[ickyvicky125]

Hi, long story short i had corsair link to control my fans (HD 120mm)and LED strips. (x4) . When iCue rolled out i installed it and it wouldnt detect my fans at all. I went back to corsair link and said “lighting node pro controlled by icue”. So then i uninstalled iCue , uninstalled corsair link. Tried one of each , still wont detect my fans even after updates. What do i do?? Thank you 

[Corsair Nick]

Sounds like the Commander Pro might need to be setup still.  Can you post screenshots of the Lighting Setup highlighted for Commander Pro, and how you have both lighting channels set?

[ickyvicky125]

On 4/20/2018 at 5:20 PM, Corsair Nick said:

Sounds like the Commander Pro might need to be setup still.  Can you post screenshots of the Lighting Setup highlighted for Commander Pro, and how you have both lighting channels set?

Hi nick, how would i go about that? Which program should i use? Icue??

[ickyvicky125]

On 4/20/2018 at 5:20 PM, Corsair Nick said:

Sounds like the Commander Pro might need to be setup still.  Can you post screenshots of the Lighting Setup highlighted for Commander Pro, and how you have both lighting channels set?

Hi nick, how would i go about that? Which program should i use?

 

On 4/20/2018 at 5:20 PM, Corsair Nick said:

Sounds like the Commander Pro might need to be setup still.  Can you post screenshots of the Lighting Setup highlighted for Commander Pro, and how you have both lighting channels set?

Its only showing the lighting node pro. 

[ickyvicky125]

Hi nick. I discovered it was a firmware issue and had to manually reset it. Thank you for your help!

[Corsair Nick]

Good to hear you were able to get it to work.  Let me know if you run into any issues later on.