Ryzen Error

[Hugs12343]

Hi guys,

 

I've been wanting to fix this problem I've had for a while. Can't find a fix on internet.

 

When I start my computer, my overclock works fine. 3.9GHz under load and 3.6 at idle (specs & OC's in signature). But when I put my computer to sleep then wake it up again, overclock stops working and max speed is 3.6 GHz.

 

I couldn't figure out the problem until now. In event viewer, I get errors after wake from sleep:

Performance power management features on processor 11 in group 0 are disabled due to a firmware problem. Check with the computer manufacturer for updated firmware.

The source is Kernal-Processor-Power (Microsoft-Windows-Kernal-Processor-Power). Event id 35. Task category (2) and windows event viewer say this is an error.

 

This is then followed immediately by an information level log.

 

Processor 11 in group 0 exposes the following power management capabilities:

Idle state type: ACPI Idle (C) States (2 state(s))

Performance state type: None
Nominal Frequency (MHz): 3593
Maximum performance percentage: 100
Minimum performance percentage: 100
Minimum throttle percentage: 100

Same source as before. Event ID 55. Task category (47)

 

These two logs occur 11 times after wake from sleep. Not after computer start

 

How can I fix my Overclock problem and get rid of these errors

 

Help much appreciated.

[Hugs12343]

Update. I just updated to latest UEFI (4.60).

 

https://www.asrock.com/MB/AMD/Fatal1ty X370 Gaming K4/index.asp#BIOS

 

It fixed my problem of overclock not working after a wake from sleep.

 

But now Task manager incorrectly reports clock speed. It says it is at 3.6 GHz but cpuz and ryzen master say 3.9GHz. Not worried though because now I get much better overclock performance.

 

Any tips for overclocking appreciated though.

 

Oh and I did disable global c-states. People say it improves overclock performance.

 

I am using ryzen balanced windows power plan