steamOS problems entering first command

[technovore]

Pic says it all.
According to this guide, that's the command I have to enter: http://steamcommunity.com/groups/steamuniverse/discussions/0/648814395797000712/
Am I doing sth wrong here?

[orangecat]

I got past the install but it wouldn't boot in my VM. I also herd that only nvidia cards are supported so it might not even run in a VM at all.

[technovore]

I got past the install but it wouldn't boot in my VM. I also herd that only nvidia cards are supported so it might not even run in a VM at all.

It does in this video: https://www.youtube.com/watch?v=glTxRlT1RpM

[needmorewood]

ur not typing is properly its case sensitive 
the second attempt u have to have FS as capatalized

[legopc]

ur not typing is properly its case sensitive 

the second attempt u have to have FS as capatalized

dont think that will work becaus i also have the same issue and typing it capatalized didnt make a difference 

[technovore]

ur not typing is properly its case sensitive 

the second attempt u have to have FS as capatalized

 tried in all caps, didn't make a difference

[FlakeyBanana]

t might not be FS0:\, type "map" and see if that directory exists on one of the other devices.

[technovore]

t might not be FS0:\, type "map" and see if that directory exists on one of the other devices.

I'm not a linux expert

[FlakeyBanana]

replace FS0 with BLK0 and try

[technovore]

replace FS0 with BLK0 and try

it's a numerical 0 and not an o right?

[FlakeyBanana]

yep ZERO 00000 00000

[roberto++]

try press tab after typing

FS0:\E

what tab does is fill in the first known directory. if you do not get it to fill with

FS0:\EFI\

you can then type b and hit tab again and it should populate with BOOT.

 

if this does not work then you may have to check to make sure that your iso file is still mounted perhaps.

 

Pic says it all.
According to this guide, that's the command I have to enter: http://steamcommunity.com/groups/steamuniverse/discussions/0/648814395797000712/
Am I doing sth wrong here?

[technovore]

try press tab after typing

FS0:\E

what tab does is fill in the first known directory. if you do not get it to fill with

FS0:\EFI\

you can then type b and hit tab again and it should populate with BOOT.

 

if this does not work then you may have to check to make sure that your iso file is still mounted perhaps.

there was no auto-completion in any of the above scenarios

[technovore]

FIXED: I made the iso using isocreator http://sourceforge.net/projects/iso-creator-cs/files/latest/download

instead of my usual IMGBURN.

it took the auto-completion and I got a few steps further