Connections help

TheRedViper · August 2, 2017

Hello there,

I am currently putting my new pc together but I am trying to figure a few things out. Let me explain, I have an Aquaero 6 pro from Aquacomputer as a fan controller which, if I'm not wrong, has 4 channels that can hold 2.5A/30W each. However, I have two 360 rads in push/pull and a 240 in push with a 140mm as back exhaust, which means I have a total of 15 fans out of which 2 sets of 6 fans need to run together, another set of 2 then the 140mm one is alone.

My idea is this: use a Splitty9 from Aquacomputer to connect the 6 fans of the push/pull setup to the channel 1 on the Aquaero 6 (I would simply need to use the 4 pin cable included and connect it from one of the 4 channels to the white connection (input?) on the Splitty9 right?). Do that again with channel 2 for the second push/pull setup. Then use a Y splitter for the 240 rad and connect it to the channel 3 and finally connect the 140mm fan to the channel 4. Does that seem to work?

The push/pull setup is 3xNB eloop B12-ps (0.08A/0.95W each for a total of 0.24A/2.85W) with 3xBe quiet! Silent wings 3 pwm high-speed (0.37A/4.5W each for a total of 1.11A/13.5W) so the whole setup would require 1.35A/16.35W per channel. Sounds right to me?