Corsair h60 problem

[Laksen]

Hey guys,

I may have a problem with my pump, it seems as if when starting are running with some air in the loop, but then after it gets used a bit (5-10 min) the sound disappears, I have not been able to find any leaks or such on the pump/cooler and it runs at the same temps as it has always done.

Specs

• AMD Phenom II 965 @ 3,4 GHz(with Corsair H60 cooler)
  
• GIGABYTE GA-MA770T-UD3 (rev. 1.4)
  
• 4 gb kingston, and 8 gb kingston hyperx blu @ 1333 MHz
  
• Gigabyte GTX 660ti OC edition @stock
  
• 1 TB Samsung spinpoint HDD
  
• 256 GB Plextor MP5-Pro SSD
  
• Optical drive no name
  
• cooler master elite 430 black
  
• ASUS Xonar DGX
  

[Whaler_99]

There is always a little air in the loop. Most AiO will make the old "buble" noise after being off for a while and will quiet down after being run for a bit. This is normal. If you didn't notice before maybe you were just lucky then with your bubbles? :)

My Antec Khuler 920 would make an aweful racket after being off for any amount of time for the first few minutes while everything got properly circulated.

[LimeDk]

yeah it normal to have air in you AiO loop my h50 after every time i move my pc around the first boot you can hear the water rushing though the loop (=

[Laksen]

well I guess it's all right then, isn't it bad for the pump not to be under water the whole time, like the swifttech h220 Linus just tested?

[Whaler_99]

well I guess it's all right then' date=' isn't it bad for the pump not to be under water the whole time, like the swifttech h220 Linus just tested?[/quote']

It's just working out some bubbles. It's fine. The issue is if your pump runs with zero liquid - that is bad. :)