Can't run sli

[tvno]

Just installed a new rig and nvidia control panel gives no option to sli. I go to device manager and one of the cards has an exclamation mark on it in a yellow triangle what do I do next?

[tvno]

It also says "windows has stopped this device because it has reported problems (code 43)

[Villevillekulla]

Do you have installed the SLI bridge? (often included with the MoBo)

And you have the latest drivers for both Mobo and GPU?

[Tedster]

Could you give us a screenshot?

 

Also, what's your full specs?

[REX.exe]

Just installed a new rig and nvidia control panel gives no option to sli. I go to device manager and one of the cards has an exclamation mark on it in a yellow triangle what do I do next?

Here are some potential causes.

 

• Not enough power (wattage)
• Faulty card
• Not connected properly
• Faulty PCIe Slot

What's the rest of your build?

[tvno]

MSI z97s KRAIT edition mono

Intel i7 4790k

X2 gtx 970s

850w psu

16bg ram

1tb hdd 500gb ssd

[tvno]

Here are some potential causes.

• Not enough power (wattage)
• Faulty card
• Not connected properly
• Faulty PCIe Slot

What's the rest of your build?

MSI z97s KRAIT edition mono

Intel i7 4790k

X2 gtx 970s

850w psu

16bg ram

1tb hdd 500gb ssd

[REX.exe]

Have you got an SLI bridge?

 

SNIP

[tvno]

Yes I have two

[tvno]

Have you got an SLI bridge?

Yes I have two

[tvno]

Bump

[RedSphyxis]

Bump

the code 43 is usually associated with driver failures. So try checking if you installed the right drivers.

 

and it can also rarely mean that one of the GPU's is dead/defective try checking both out 

[tvno]

PROBLEM SOLVED:

I started by putting each into each others PCIe slot ect and then one was fine one was not powering up. I realised I'd connected 12 instead of 14 power pins into the gpu so it wasn't powering (although the 12 was fine for one of the graphics cards) both have 14 pins in and now fine