Ender 3

[The_dude13]

Im getting an error maxtemp e1 printer halted when im tring to load filliment as the print head reaches 200. I have tryed loosening the set screw on the bottom of the Hot end and that didnt work. I was given this printer from a friend because he had issues with the hot end. I put a new hot end on it and tryed uploading to the newest firmwear and i have had nothing but issues. Any help will be appeated. I can also supply pictures as well. Thank you in advance.

[manikyath]

that error either means that the temp sensor is reading something wrong (short circuit or open circuit), or apparenlty also if it detects a thermal runaway.

 

are you sure everything is assembled correctly, and all the connections from the hotend to the motherboard are properly seated?

[The_dude13]

To the best of my knowladge and according to the diagrams i can find online yes. I did loosen up the thermister slightly and that allowed the temp to reach correctly now im haveing a feeding issue.

[The_dude13]

32 minutes ago, manikyath said:

that error either means that the temp sensor is reading something wrong (short circuit or open circuit), or apparenlty also if it detects a thermal runaway.

 

are you sure everything is assembled correctly, and all the connections from the hotend to the motherboard are properly seated?

To the best of my knowladge and according to the diagrams i can find online yes. I did loosen up the thermister slightly and that allowed the temp to reach correctly now im haveing a feeding issue. Its also a new hotend.