3D printer Question.

[Sir Judgementz]

hey you guys i have a question. I got the Ender 3 S1 (non pro version or whatever, just the S1) and the filament melted to where it broken the hot end. couldn't remove it be cause the screws was striped. so i got this as a replacement (list both my printer and what i got and the end). I connected the Ender 3 S1 to the new the extruder and all looks good. i did 3 prints and came out great. I know the CR-10 Smart Pro comes with an entirely all-metal hot end, which allows operating at higher temperatures of up to 300° C, but that's not why i got it. i will be using it the same way i used the stock one. Is there anything i need to worry about here? thanks for all your help.

 

heres what i have and what i got:

I have this

https://www.microcenter.com/product/642018/creality-ender-3-s1-3d-printer

And I replaced it with this and it works:

 

https://www.microcenter.com/product/667195/Complete_Extruder_Replacement_Kit

[cekcons]

If all connections are fine and you got proper temp reading then its all good.

Most important thing is proper temp reading while thermometer touches the heater. 3d printers can be customized easy with random parts just be sure it connects to right pins. In your case you already connected and works so pin match up is correct.

[Biohazard777]

For potentially better results (and less head scrathing down the road),
PID tuning (read what it does: https://all3dp.com/2/3d-printer-pid-tuning/)

For your printer:

[Sir Judgementz]

thanks