Need help with connecting unknown touch display

DoesThisWork · March 21

Hi,

I am currently trying to upgrade some cash registers, so they don't just land in the trash.

Current system specs

Motherboard: Partner S1-J1900-A
CPU: Intel Celeron J1900

HWiNFO Display

Spoiler

Digital Flat Panel (1024x768)


[Allgemeine Informationen]
	Monitorname:	Digital Flat Panel (1024x768)
	Seriennummer:	3
	Herstellungsdatum:	Woche: 0, Jahr: 2002
	Hardware-ID des Monitors:	Monitor\MS_0003

	Horizontale Frequenz:	235 - 235 kHz
	Vertikale Frequenz:	60 - 60 Hz
	Maximaler Pixeltakt:	70 MHz

[Erweiterte Parameter]
	Eingangssignal:	Digital
	Farbbit-Tiefe:	8 Bits per Primary Color
	Digitaler Video-Schnittstellenstandard unterstützt:	DisplayPort
	Gamma Factor:	3.55

[DPMS-Modi]
	Standby:	Nicht unterstützt
	Suspend:	Nicht unterstützt
	Active Off:	Unterstützt
	Standard Colour Space (sRGB) Default:	Unterstützt
	Preferred Timing Mode:	Unterstützt
	Default GTF (Continuous Frequency):	Unterstützt
	DFP 1.x Compatible:	Ja

[Unterstützte Videomodi]
	1024 x 768	0 x 0 mm, Pixeltakt 65.00 MHz

[Informationen zum Gerätetreiber]
	Treiberhersteller:	(Standardmonitortypen)
	Treiberbeschreibung:	Digital-Flachbildschirm (1024x768 60Hz)
	Treiberanbieter:	Microsoft
	Treiberversion:	10.0.19041.3636
	Treiberdatum:	21-Jun-2006
	DeviceInstanceId	DISPLAY\MS_0003\4&39E1B30F&0&UID68092928
	Standort-Pfade	ACPI(_SB_)#ACPI(PCI0)#ACPI(GFX0)#ACPI(DD1F)

My issue right now, is that I cannot figure out, how I can connect the touch display.

There are 3 cables that I need to connect. I am assuming that 1st is for data, 2nd is for power and the 3rd is for touch.

20 pin connector => Only 18 pins
5 Pin connector => Only 4 pins
4 Pin connector

My thought was looking for a board that maybe I can connect those cables to and then a HDMI or DisplayPort cable comes out of the other end. Not sure how I would get the touch display working though.

Does anyone have an idea? I am curious and excited for your help! Let me know if you need anymore information.