Bios and Boot Startup Problem

[Puppeteer]

Hi, 

I have 2 issues with my mobo;

 

1) During 1st startup the q-led post code for gpu wont light-up (Pic 2) (no display/blank) unless I press reset button then it boot up normally, which annoyed me for each startup. Before these im using b450m steel legend and never encounter these problem. I already check the pcie slot and ram slot (reseat it), remove cmos battery and still it happen for every 1st start-up.

 

2) Refer Pic 1, my mobo show no NB and SB configuration, is there a solution for these? Do I need to reflash same bios version?

 

Another thing is my GPU in AMD driver show it run on PCIE GEN 3x16 instead of 4x16. Do I need to upgrade the cpu (3000/5000series)?

 

My PC Spec:

Motherboard - Colorful CVN X570M Gaming Frozen V14 (Bios V 1005 - latest)

CPU - Ryzen 5 2600

Ram - HyperX Fury 3200mhz 8GB x 2

GPU - Nitro+ RX 5700xt

Storage - 256GB M.2 NVME Adata Sx 6000lite, 480GB WD M.2 SSD SATA

PSU - Superflower Gold Leadex V PRO 850W +Gold

 

Thank You. Hope can help me in these issues.

[Fasauceome]

42 minutes ago, Puppeteer said:

Another thing is my GPU in AMD driver show it run on PCIE GEN 3x16 instead of 4x16. Do I need to upgrade the cpu (3000/5000series)?

B450 only gives you PCIe 3.0

 

43 minutes ago, Puppeteer said:

2) Refer Pic 1, my mobo show no NB and SB configuration, is there a solution for these? Do I need to reflash same bios version?

Which settings are you looking for?

[Puppeteer]

8 hours ago, Fasauceome said:

B450 only gives you PCIe 3.0

 

Which settings are you looking for?

Now im using CVN X570M Gaming Frozen V14 (Colorful Mobo) which support pcie 4.0, but im using Ryzen 2600, so do I need to upgrade processor?

 

I just wondering why my MOBO bios didnt have option for chipset (North and South Bridge Configuration), do i need to reflash bios again?

 

Any ideas why 1st boot-up show no display unless I press reset button to boot-up normally?

 

[Fasauceome]

1 minute ago, Puppeteer said:

so do I need to upgrade processor?

correct, the Ryzen 5 2600 only has PCIe 3.0. Although, it won't exactly make much difference, if you upgraded to something like a Ryzen 5 3600 the CPU performance itself would make the real difference.

 

2 minutes ago, Puppeteer said:

I just wondering why my MOBO bios didnt have option for chipset (North and South Bridge Configuration), do i need to reflash bios again?

 

I'm not familiar with the motherboard you are using, so unfortunately I can't comment on the BIOS layout. However, I do not know what chipset configuration settings you would want, because as far as I am aware, modern motherboards give controls for all the devices attached to the chipset in their own menus, such as PCIe mode and USB settings.

 

3 minutes ago, Puppeteer said:

Any ideas why 1st boot-up show no display unless I press reset button to boot-up normally?

 

This can be caused by quite a few things. Corrupted BIOS chip, power supply problem, memory errors, etc. You might want to experiment with other parts, if a friend can lend some computer parts to test it would help you narrow down the problem.