GPU wobble ?

[espr3ss0]

I've just tried putting my GPU (Gigabyte 2070s Gaming OC x3) back in after having to take it out and even though the catch on the MB suggests it's slotted in I can't get the screws into the case properly as there is a slight gap I have to really push it down. Not only that but it's really wobbly, if there were no screws it feels as if it could fall over, usually there is a cm or 2 give but this is now an inch or so.

 

Any suggestions from u kind ppl ?

[Skipple]

You almost certainly don't have the GPU seated properly. Remove the GPU by pushing the tab at the back of the PCI-E slot and pulling up. Re-seat it again. The top of the bracket should sit flush against the back of the case. 

[espr3ss0]

I've tried over and over but it's not wanting to sit all the way in. The tab on the MB is up so it is slotted in, and does sit against the case but not where the srew fits. I can't see a problem. The GPU seems to work fine anyway.

[Skipple]

12 minutes ago, espr3ss0 said:

I've tried over and over but it's not wanting to sit all the way in. The tab on the MB is up so it is slotted in, and does sit against the case but not where the srew fits. I can't see a problem. The GPU seems to work fine anyway.

Can you upload a photo(s)?

[espr3ss0]

Yes but of what exactly ?

[Skipple]

19 minutes ago, espr3ss0 said:

Yes but of what exactly ?

I would like to see the bracket at the back of the case and the PCIE slot under the GPU if possible. Just want to see if I can't spot anything. 

[espr3ss0]

Sorry it's taken a while had a busy week. No need for photos, I'cve found the problem ! It was my cable management at the back enclosure interrupting it slotting all the way in.