CPU problems

[VenomousG]

Finished my pc and so far looks good, I end up having a cpu heating problem.  I don’t know how to control my pump and my cpu is getting hot.

[NotSoEpicMods]

Not exactly sure what you're asking here and you pictures don't exactly give a lot of information. First thing first, that bios CPU temp is not normal even if it was an offset temp sensor it doesn't seem right. Looks like you're using the Corsair pump/res combo which has a pwm pump which should be plugged into a pump header on the motherboard but for testing I would plug it into a fan header adapter pulling power directly from the psu so it will run at full speed. Iif that doesn't help temps I would double check the cpu block mount make sure proper thermal paste spread is achieved.

[Mick Naughty]

Well do you know how to adjust the fan profile?

the pump is plugged into the cpu heads as it reads 4K plus rpm. 

 

So I assume it bled without issues? Didn’t you post about something earlier?

 

If you were to cold boot into the bios, as in the pc wasn’t on for a long time and it got that hot, it’s a mount issue. Even with no flow, just having the block on it with fluid would keep the temps much lower than that. 

 

So some more info could help. As in cold boot temps. Leaning towards block install issues of some kind.