Meshify C Front panel AIO Mod

[Benj1]

So I came to regret buying an Noctua NHD-15 and wanted to by a 280mm AIO instead. I've done this mod but can't seem to fit an AER P 140 which would be the fans that comes with the AIO. The issue i'm facing is that the fans is touching the front mesh. Does anyone have any other ideas as to what mods i could do?
*Graphics card is a ASUS stix 1070 so it won't all fit inside
Thanks - Benj1

[narrdarr]

I have the same case.

Put the fans in a pull configuration

[narrdarr]

[Benj1]

6 minutes ago, narrdarr said:

Put the fans in a pull configuration

So i just put the fans inside and then the AIO behind the panel instead? o:

[narrdarr]

Put it all inside 

You can put the fans in push or pull I just think it looked better in a pull configuration

[Benj1]

2 minutes ago, narrdarr said:

Put it all inside 

Forgot to add that i have a Asus strix 1070 so it won't all fit inside^^

[narrdarr]

Is the rad slimmer than the fans?

Will the rad fit between the front panel and the case?

 

Or just get a dark rock pro instead

[Benj1]

Sadly not
Rad: 315 mm x 143 mm x 30 mm
Fans:140 mm x 26 mm

[narrdarr]

The only other thing I can of is a custom loop. With 2 rads one 140mm top front 1 120mm rad in the back.  

 

Or make it easy and get smaller gpu version.

[Benj1]

Think i'll wait around to and see if anyone comes up with some more modding, else i might look at trading to a shorter card 

[narrdarr]

IIf you really want to mod the case you cut the front part of the chassis off. Then use some L bracket to mount too.

But it will be a really tight fit and any error may cost you the utilization of front all together