Random System Freeze

[FLACS]

Hi There,

I'm facing random system freeze problem. These are the following issues I face:

1. Whenever I start my system it freezes and hangs at the loading screen or
2. Sometimes when I power ON then it Powers off automatically and power ON automatically and ends in an ON/OFFloop.
3. After loading, a few minutes later I end up in some random blue pixelated screen and system hangs there.

I usually do a few workarounds such as remove the graphics card and RAM and then power ON and place back the same GPU (Titan X) it works or if I remove few RAM sticks it works or I switch to Quadro card it works.

But the issue is when I switch back to Titan X it works well for few days (i.e. temps are all good idle around 35 deg C) and after some days of using it again goes back to the above problems.

This my system Spec

CPU: Core i7 5820K (NOT OVERCLOCKED)
RAM: Corsair Vengence LPX 64 GB (each 8 Gig Kit)
GPU- Titan X (Maxwell) (NOT OVERCLOCKED)
Motherboard: MSI Gaming 7 X99A
PSU:  Corsair CX750M

Please, anyone, tell me what would cause this issue is it some power shorting issue? or my GPU is dying.

Thanks

[Ashleyyyy]

i know i'm asking a stupid question, but is your ram oc'd? even just XMP? if so, turn it off... 

[FLACS]

XMP off, not overclocked

[FLACS]

2 minutes ago, firelighter487 said:

i know i'm asking a stupid question, but is your ram oc'd? even just XMP? if so, turn it off... 

XMP off, not overclocked

[Praxis727]

could be a power consumption thing.  Under load the titan x maxwell takes 370 plus and it is like 2 and some change for the ram. Basically 600watts right there.  Leaves you 150 watts or so to run literally everything else (not to forget to mention the 5820k can use a lot of power) and that is on a bronze corsair psu.  So there are bound to be dips in output.  I am saying power issue.

[FLACS]

35 minutes ago, Praxis727 said:

could be a power consumption thing.  Under load the titan x maxwell takes 370 plus and it is like 2 and some change for the ram. Basically 600watts right there.  Leaves you 150 watts or so to run literally everything else (not to forget to mention the 5820k can use a lot of power) and that is on a bronze corsair psu.  So there are bound to be dips in output.  I am saying power issue.

Thanks, what PSU would you think is sufficient for my config 

[Praxis727]

under full load bout 260 for ram, 370 or more for gpu and 300 or so for the processor. I would recommend at least a 1000w.  Any of the standard brands should do.   

EVGA 210-GQ-1000-V1 GQ 80 Plus Gold, 1000W ECO Mode Semi Modular Power Supply  there is a corsair one that is the equivalent.   Leaves a little overhead room.