Building my first custom loop

[Horsin_Aorund]

I'm building a custom loop for my PC and wanna me sure these parts will all work together and in the NZXT H200I case.

 

Case link: https://www.nzxt.com/products/h200i-matte-white

 

It will also have a gpu water block for my evga 980ti SC

 

This one - https://www.ekwb.com/shop/ek-fc-titan-x-nickel

 

If you really want/need the specs of my pc they are on my profile.

Spoiler

[Mick Naughty]

Looks good so far. I would get a 280 rad. Also need actual fittings of some kind to attach the hoses. Recommend compression if you can afford it now but ive used plenty of barbed fittings with zipties.

[Horsin_Aorund]

17 minutes ago, Mick Naughty said:

Looks good so far. I would get a 280 rad. Also need actual fittings of some kind to attach the hoses. Recommend compression if you can afford it now but ive used plenty of barbed fittings with zipties.

Should I include some sort of bleed valve?

[Mick Naughty]

To save yourself headache down the road, yes.

I finally put some in my rigs after doing this over a year. Always make a mess without one.

[Horsin_Aorund]

how would I include that into this setup? 

 

[Mick Naughty]

10 minutes ago, Horsin_Aorund said:

how would I include that into this setup? 

 

A "T" fitting. A male to male adapter and the drain valve itself. Somewhere at the lowest point where if could drain the most fluid.

[airdeano]

if you'll use 1/2" barb fittings and 7/16" ID tubing, clamps/ties will not be necessary.