My New Build

[Australian-n00b]

Well I told my self that i will not start building this new PC of Mine until I had all the parts.

 

But me been me i pulled out my New Corsair Crystal 570X to have a peep and then went to let see how the fits look for my Water Cooling Loop (already found issues with Fit's Bugger)

 

With the Front i can just fit in the Res/Pump combo but its just rubbing on the cases power supply cover i am not overly fussed over but i do have the issue now of tiring to fit my Asus GTX 1080 ROG Strix OC Card in......

 

Then i went stuff this i am starting so tossed in my MB and CPU with its EK supremacy Evo Water block 

 

Next I tossed in my Cablemod Cables so i can start the head ake of cable management as this is going to be a nightmare as is in this case

 

other wise its turning out nicely so far. 

[Cyracus]

do you even use the front panel audio? with nice sleeved cables I'd just omit it since that front port is pretty much never used

[Australian-n00b]

1 minute ago, Cyracus said:

do you even use the front panel audio? with nice sleeved cables I'd just omit it since that front port is pretty much never used

I will be addressing that to the same as my EK Pumps cables there also not sleeved

[jcw150]

What's the plan for the loop order, just wanting to imagine it, it's looking like it'll be very nice

[Australian-n00b]

54 minutes ago, jcw150 said:

What's the plan for the loop order, just wanting to imagine it, it's looking like it'll be very nice

I am not running the GPU at the time but i am still undecided on order 

[Australian-n00b]

 

57 minutes ago, jcw150 said:

What's the plan for the loop order, just wanting to imagine it, it's looking like it'll be very nice

2 minutes ago, Australian-n00b said:

I am not running the GPU at the time but i am still undecided on order 

To say that the odd thing is most is not on display as you can see i am running the pipes behind the MB to keep the main chamber clear and to keep it clean as i can .

 

as with soft tubing it is hard to make good runs and if i was running hardline it would be a different story.

 

then all the connections to the pump and rad will be hidden by the power supply shroud.i know that a Custom loop should be for show but there is a way i want this rig to look.  

[Australian-n00b]

Will be doing a Size test with my GPU tonight to see how much space i dont have with my Pump/res combo

 

more photos to come of that

 

 

[Australian-n00b]

Ok now i have a problem

 

Pump res combo does not fit........ at 180 millimeters and only have 170mm to the gpu from the bottom of the case....

 

Think i might have to get a smaller pump / res combo bugger and mount it to the bottom of the case

 

But i love how cablemod cable look and run

 

I will get the gpu power up higher later when i get the back cable managed more