Any advice on Aerocool Strike-X One regarding its airflow?

[ORGASMATRON]

I followed the one on the website which is a Negative Airflow. (I think)

 

1 x 120mm INTAKE Fan on the Front. (Always running on Full RPM)

1 x 120mm OUTTAKE Fan on the Bottom. (Determined by my custom profile on Fan Xpert 2)

1 x 120mm OUTTAKE Fan on the Back. (Determined by my custom profile on Fan Xpert 2)

2 x 120mm OUTTAKE Fan on Top. (Determined by my custom profile on Fan Xpert 2)

2 x 120mm OUTTAKE Fan on the Side Panel. (Connected directly on the PSU, I still need a 3-pin Y-Splitter)

 

Temps seems decent on idle and on a hot day even with the AC turned off and only using a stock cpu cooler.

 

I am planning to get a Cooler Master Hyper 212 EVO just to make it a little cooler even though I don't even overclock it.

 

I also like to change my Airflow to Positive, since that's the orientation that Jayztwocents recommended.

 

 

So, what are your thoughts on this, guys?

[ThatGuyNamedKasper]

1,3 and 6 should be intake fans while 2 and 5 will be outtake fans. This will cause positive air pressure meaning no dust build up as all of hot air has two escape via 2,5 or the graphics holder mesh place. 

[ORGASMATRON]

1,3 and 6 should be intake fans while 2 and 5 will be outtake fans. This will cause positive air pressure meaning no dust build up as all of hot air has two escape via 2,5 or the graphics holder mesh place. 

Thank you, sir!

[ThatGuyNamedKasper]

Thank you, sir!

np