Inwin 904 airflow mod

[TheIcedCanadian]

hi,

I really like the look of the inwin 904 , but have been but off buying it because of its horrible airflow. I was wondering what you guys should think I should do. I have some rough ideas, but I will take a few suggestions firsT

Thanks, and merry chirstmas!!

[officiallyasimulator]

take the side panel off and duct tape a desk fan to it

[coen113]

Maybe cut some slots in the front panel, at the sides and place a fan there?

[TheIcedCanadian]

take the side panel off and duct tape a desk fan to it

 

 

Maybe cut some slots in the front panel, at the sides and place a fan there?

 

Here is a basic render of what I will probably do:

I will use the bottom 2 for intakes and the back one for an intake aswell - I know it is supposed to be used as an exhaust, but If I use it as an intake it will push lots of air through the cpu air cooler. Then the top 3 as intakes.

Fan sizes:

Back (comes with) - 90mm

Bottom (comes with) - 140mm

Bottom (modded) - 140mm

Top (modded) - 140mm x3

[coen113]

What about the psu? Doesnt that go in the bottom?

[MourningSouls]

Dark Rock Pro is a bit too big for this case, only fits up to 145mm air coolers. It's really intended to be used with AiO's.

[TheIcedCanadian]

What about the psu? Doesnt that go in the bottom?

It does- it fits somehow - I don't have the case and the fan that is there is included so I am currently not sure how it works:P

[TheIcedCanadian]

Dark Rock Pro is a bit too big for this case, only fits up to 145mm air coolers. It's really intended to be used with AiO's.

OK - now that I think about it I could get the Thermaltake AIO that has a 360mm radiator and put that up the top.

[gylmir]

Here is a basic render of what I will probably do:

I will use the bottom 2 for intakes and the back one for an intake aswell - I know it is supposed to be used as an exhaust, but If I use it as an intake it will push lots of air through the cpu air cooler. Then the top 3 as intakes.

Fan sizes:

Back (comes with) - 90mm

Bottom (comes with) - 140mm

Bottom (modded) - 140mm

Top (modded) - 140mm x3

 

you want to build a case with no exhaust ? only 6 intakes ? do you have some mesh around to push the air out and not having to much over pressure.

[TheIcedCanadian]

you want to build a case with no exhaust ? only 6 intakes ? do you have some mesh around to push the air out and not having to much over pressure.

Top 3 as outtake I meant

[gylmir]

Top 3 as outtake I meant

ow that makes more sense to me can't wait to see results.