Is there a touch screen led strip controller?

[QuadNine]

is there a touch led controller like the NZXT rgb controller? I want my  build to be slick and look nice without knobs and such. I feel that the knobs would just make it look ugly. I will be using Corsair 230t orange edition with an optical drive an NZXT sentry 3.

Thanks

Nejat

[W-L]

is there a touch led controller like the NZXT rgb controller? I want my  build to be slick and look nice without knobs and such. I feel that the knobs would just make it look ugly. I will be using Corsair 230t orange edition with an optical drive an NZXT sentry 3.

Thanks

Nejat

 

I don't believe there are such units out there for mounting in a 5.25" bay but you can get an RGB controller that is wireless and uses a remote control to change the colors and modes of lighting.

 

http://www.icemodz.com/webshop/#!/RGB-Control-box-and-Remote/p/22337024/category=9311248

 

http://www.newegg.com/Product/Product.aspx?Item=N82E16811994051

[QuadNine]

I don't believe there are such units out there for mounting in a 5.25" bay but you can get an RGB controller that is wireless and uses a remote control to change the colors and modes of lighting.

 

http://www.icemodz.com/webshop/#!/RGB-Control-box-and-Remote/p/22337024/category=9311248

 

http://www.newegg.com/Product/Product.aspx?Item=N82E16811994051

Thanks I think I will Go for that to make my build a bit cleaner!

[Cooleb09]

is there a touch led controller like the NZXT rgb controller? I want my  build to be slick and look nice without knobs and such. I feel that the knobs would just make it look ugly. I will be using Corsair 230t orange edition with an optical drive an NZXT sentry 3.

Thanks

Nejat

You could connect the LEDs to the +v on a three pin from a nzxt sentry controller, although you may need some kind of converter in between (either an op amp, or an arduino). That would only give you the ability to control brightness though. With a sentry however you could hook it up to the +v from three 3 pin connectors, and use an Arduino to turn those voltages into a final voltage to send to some RGB LEDs in parrelel.