Inlets and Outlets and Loop

[hobsonshah]

So made a post yesterday about my loop going titsup now i am going to see if i can get help on here to sort out the loop again and do it properly.

 

I had a rad leak which will get fixed but unfortunatly the way i had my loop it was just pumping liquid straight into the res in such away that it would hit the top. Below is the old loop.

 

 

Now this is the new loop but i did it via paint. Ive marked the inlets and outlets correctly on some parts (Not sure if they are 100% correct). Is this correct? Can someone help?

 

 

I have a d5 vario pump with xtop, a EK Supremacy Evo CSQ WB, 780Ti Waterblocks full cover 2*. Xt45 240 in the front and a ST30 360mm in the top. Do you recommend anything other? I only have one hole in the top of the res thats what i use to fill the res.

[Shroomster]

That is correct.

[Shroomster]

It WILL work. Or should at least.

[acidprototype]

Looks about right to me but im a bit confused on the paint image. Some of the inlets and out lets dont make sense when i follow the line coming out of the pump.

[hobsonshah]

Looks about right to me but im a bit confused on the paint image. Some of the inlets and out lets dont make sense when i follow the line coming out of the pump.

Could you tell me a bit more about this? Cuz if there is a problem I must fix it thnx

[acidprototype]

 

 

Just to clarify the flow goes pump - gpu blocks - top rad - cpu - front rad - res - pump?

If so then it is fine.