tpm 2.0 problem

[astheniaa]

guys can you help, what could be the reason when i put tpm device selection with enable firmware tpm, it resets to enable discrete tpm? i press f10 when i exit. Motherboard asus prime h410 m-k r2.0, bios updated to the latest version did not help. csm is off and os type is uefi.

[YoungBlade]

I assume "F10" is "Save and Exit" on your board?

 

When you change TPMs, the motherboard will typically require a confirmation of some sort, either immediately or on the next boot. If you say "no" or fail to give an answer after a certain amount of time, it will revert back to the previous setting. Does your screen have any kind of "are you sure?" message pop up?

[astheniaa]

3 hours ago, YoungBlade said:

I assume "F10" is "Save and Exit" on your board?

 

When you change TPMs, the motherboard will typically require a confirmation of some sort, either immediately or on the next boot. If you say "no" or fail to give an answer after a certain amount of time, it will revert back to the previous setting. Does your screen have any kind of "are you sure?" message pop up?

when you switch from discrete to firmware write this plate and OK.