Kolink Void X GPU Cooling

[iW1CKED]

Hello,

Is it possible for me to add extra fans to the bottom somehow for additional GPU cooling in the stated case? There aren’t any screwholes there for me to install them but maybe I could just set a fan to the bottom there without screwing? Or maybe with a strong two-sided tape if that doesn’t lose it’s stickiness with the heat.

Thanks in advance.

[OddOod]

Nope. There is no new air supply to that region. At best you'd just be stirring the air around a bit which won't be a noticeable improvement.
You'd have to cut out the PSU shroud, then cut holes in the bottom at which point you're putting in a LOT of effort to compromise the structural integrity of the case instead of getting a better case. 

 

[iW1CKED]

14 minutes ago, OddOod said:

Nope. There is no new air supply to that region. At best you'd just be stirring the air around a bit which won't be a noticeable improvement.
You'd have to cut out the PSU shroud, then cut holes in the bottom at which point you're putting in a LOT of effort to compromise the structural integrity of the case instead of getting a better case. 

 

Thank you. I guess I’ll roll with how things are right now. 73-78 degrees I hope is pretty good for a 3080 Ti under heavy load.

[OddOod]

9 minutes ago, iW1CKED said:

pretty good for a 3080 Ti

It's more of a problem for the 90 but do double check the memory temps. HWMonitor should tell you what's the limiting factor.