Graphics Card Problem

[ParksNeedsHelp]

Hello,

Hopefully, I am posting in the correct area. This is my first post. If anything is wrong, please let me know. I am having some issues with my graphics card that I hope someone can help me solve. I have a 3090 GPU that was running four monitors. Three of these monitors are 1080p, and the main display was 1440p. I wanted to upgrade my primary display to 4k. I changed the monitor and upgraded my graphics driver when I did this. I used all the same cables. ( I did change out for different cables to see if that was the issue, and it was not). Three of which are display ports, and the fourth is HDMI. When I first booted the computer, it would continually boot loop and give different error codes. Some of the codes were for ram or other random issues. I reseated the ram and tried again. After a few tries, I thought it might be a GPU issue, so I unplugged them all except my 4k display. Booted right up with no issue. Then I plugged in another and booted. The same result booted with no issue. The same is true for the third monitor. When I plugged in the fourth same issue, the boot loop. I tried switching ports around on the card to see if the issue was the card itself, and all the ports worked. Now when the computer is on and I plug in all four monitors, I get a signal on three monitors. If I switch the cables around, I still only get a signal on three monitors. When I go into the Nvidia control panel, I can see all four monitors, but when I try to add the fourth to be used, it disables another one (picture attached). When I go into windows display settings, I can see all four in the area they should be, and the monitor with no signal (labeled with a 1) says that the display is disconnected. When I tell it to extend to that display, it does nothing. Hopefully, there is a simple solution, but I have been googling for a while with no solution. I really hope I do not need to buy another GPU because I need all four displays. Any help would be greatly appreciated. Thank you.

 

 

System specs

Fully water-cooled pc no overclocking

Windows 11 with all updates

Nvidia driver updated

AMD 5950x

MSI MEG ACE x570

64gb trident 3600mhz ram

MSI Ventus 3090

I have four M.2 installed

8 tb harddrive

[Dukesilver27-]

Seems obvious, but have you tried rolling back to the old drivers?

[ParksNeedsHelp]

Thank you for your reply.

 

Yes I did try this and no fix. Funny though because when I reinstalled the newest driver, I did a fresh install where it deletes everything and installed new. When my computer restarted and booted, I still had all four cables for my displays plugged in (because before it would boot loop with all four displays plugged in). But I think this was because the computer installed the graphical driver when I got into windows. Either way still no solution.