Is this normal?

[Tech Reprise]

Hi, 

I just noticed that the 220V mains cable of the PSU doesn't go in fully into the mains port.

Is it normal for the cable to not go in fully?

I pushed it as far as it can go and it sits fine and I have used this same PSU for nearly 2years now. I Just noticed this while relocating to another AC room.

 

The cable is a decent quality 10A 250V that came with my previous Corsair PSU.

My current Antec PSU came with a flat pin that is not compatible with my socket.

 

[Guest]

Normally the plug in further, but as long as it doesn't wiggle about, you should be fine.

 

[RAM555789]

Its been fine for the past 2 years I doubt its a problem, or will become one.

[Tech Reprise]

38 minutes ago, jonnyGURU said:

Normally the plug in further, but as long as it doesn't wiggle about, you should be fine.

 

Yes its pretty tight in its spot and doesn't move a mm unless pulled hard/wiggled back and forth to remove it.

Tried 2 sets of cables and neither went in fully so I think the port on the PSU side might be a bit shorter.

27 minutes ago, RAM555789 said:

Its been fine for the past 2 years I doubt its a problem, or will become one.

I hope so.