Single molex connector cable?

[JZSmith]

Is there anywhere to get a molex psu cable with just a single 4 pin molex connection. Corsairs xd5 pump + res connects via molex and i dont want to have plug in the molex cable i got with the corsair rm750 that has 5 connections taking up unnecessary space. I looked everywhere and seen that using sata to molex is not recommended.

[Spotty]

You could buy a custom cable and configure it to have just one molex connector.

If you don't mind ruining a molex cable you could just cut the rest of the cable off after the first connector. Just make sure there's no exposed wires that could short out. Maybe try to cut it as close to the connector as possible and put some electrical tape over it.

Or just use the molex cable and jam it down the bottom of the case where nobody will see it. It doesn't really take up that much room.

[JZSmith]

2 hours ago, Spotty said:

You could buy a custom cable and configure it to have just one molex connector.

If you don't mind ruining a molex cable you could just cut the rest of the cable off after the first connector. Just make sure there's no exposed wires that could short out. Maybe try to cut it as close to the connector as possible and put some electrical tape over it.

Or just use the molex cable and jam it down the bottom of the case where nobody will see it. It doesn't really take up that much room.

I wish i could just shove it in the back but with 13 corsair rgb fans, 8 led stripes, commander core commander pro, light node core, sata for 6 SSDs, its had so many wire adding in 5 connector molex for just needing one of them is a nightmare. I probably will cut them off and seal the ends, they is no problems of to much power to the one connection doing this? And is sealed properly no risk of fire?