Pc Starts- No Display.

[Themaindude202]

So, this is a long story. basically, i started off by uninstalling my gpu drivers. i had like 15 different engines and i just wanted the Radeon one for my Rx580. i was going to just run without drivers for a while, no harm right? so it says to restart pc to finish. it turns off. but now, it turns on, and the monitor says no signal. Now, before you ask, I have tried-

Reseating the RAM

Reseating the CPU

Different GPU

Different Motherboard

Different Boot Device

Nothing. 

I watched a lot of videos and the overall consensus was that my RAM was dead, or incompatible with my MOBO. so i went to best buy and got a brand new set of Corsair 16gb 3600 Speed ram, an upgrade to the samsung 16gb 2666 ram i had. i am fine with paying for the new ram, but it did not solve my problem. Does anyone have any possible clue??

CPU- Ryzen 7 1700

GPU- Gigabyte RX580 8G Gaming

(backup gpu- MSI Gt710)

Ram- noted above.

SSD- Samsung 970 Evo 1TB

Mobo-ASUS TUF B450-Plus Gaming

(Test mobo-HP8399)

[Themaindude202]

I was planning on installing the new UPDATED drivers when it opened, but no running after that.

Also, i tried many different cables, TVs, and monitors 

[shoutingsteve]

Reconnect your monitor and then do a hard restart to trigger the "windows didn't shut down properly, do you want to restart in safe mode?" dialog.  Try going through that method to reinstall video drivers.

I doubt that your uninstalling your display drivers would have lead to your ram suddenly not working.

[Themaindude202]

2 minutes ago, shoutingsteve said:

Reconnect your monitor and then do a hard restart to trigger the "windows didn't shut down properly, do you want to restart in safe mode?" dialog.  Try going through that method to reinstall video drivers.

I doubt that your uninstalling your display drivers would have lead to your ram suddenly not working.

I don’t even get a display. I can hear the system obviously booting, and if i leave it on, the parts get to a toasty temp, so i know there’s stuff happening, i just can’t see anything. but i have tried that.

in fact, i have tried almost everything i could do on this list: https://forums.tomshardware.com/faq/no-post-system-wont-boot-and-no-video-output-troubleshooting-checklist.1575220/

 

[shoutingsteve]

try reseting CMOS and removing your gpu.  Then plug you monitor into the video out of your mobo.

[Themaindude202]

did it. the motherboard has no cmos jumper that i am aware of so i just took the battery out for a couple minutes. i don’t have any integrated graphics and that did not work either.

[Themaindude202]

Still unsolved, can someone please help?