Gpu fittings

[JustSum]

Not sure what to even call the tittle.

Ok so my thing is ive been wc for the past 3 years its time to move on. Since i went from intel to amd i wont be buying a cpu waterblock, not going to spend another 50-100 on a waterblock.

So ill be buying a nhd15 or a corsair 280mm. Tryna go for the nhd15.

So my only question is can i use the top fitting on the gpu and put it on the bottom? Since the nhd15 is too big?

[johnny5c]

It's not a problem, just swap the fitting and the plug.  Only thing is you might have to lay the case on it's side to bleed all the air out of the GPU.

[JustSum]

Just now, johnny5c said:

It's not a problem, just swap the fitting and the plug.  Only thing is you might have to lay the case on it's side to bleed all the air out of the GPU.

Yeah thats not a problem . Thanks just needed confirmation.

[Neggy-Z]

You could also grab a few 90 degree fittings and an extender to loop around the block, would clean up the run and not have a huge bend in the tubing.

Also what cpu block do you have? Have you checked to see if there are AMD mount brackets for it?

[JustSum]

43 minutes ago, Neggy-Z said:

You could also grab a few 90 degree fittings and an extender to loop around the block, would clean up the run and not have a huge bend in the tubing.

Also what cpu block do you have? Have you checked to see if there are AMD mount brackets for it?

Yeah they stopped selling the kit even msg xspc but nothings. Its a xspc full copper RayStorm CPU WaterBlock (Intel) Copper. Only thing i can do is buy a xspc raystorm am4 for around 60$ and im just done if im going to spend 50 for a am4 block ill just get a noctua and call it a day and if the am4 kit ever comes in stock or someone sells it on ebay ill gladly buy it since the kit was only 15-20$.

 

Ill also probably get a 90d fitting ill see how it turns out since i can also just use my other 240mm thick rad instead of the 380mm on the gpu itll be much lower the connections.