Cryorig H7 help needed..

[A04771]

So I just got my Cryorig H7 yesterday. And I tried to install it to my cpu. But 1 out 4 supporting legs on the cooler keeps gettng tilted and not evened. As shown in the picture. So I can't even screw that one piece, is there anyway to solve this problem? 

My spec is:

H97 PLUS motherboard

I7 4790

GTX 1070

 

 

[Daveeede]

I've never installed this heatsink so I'm not familiar with the mounting mechanism, but it could be that you have the metal bracket reversed. It is also possible that you are using the wrong mounting position. Check the manual and be sure your are following the steps for LGA 1150.

[TheRandomness]

Is there a way to have access to only that bar? Because you can just bend it back. Also, are you actually installing the backplate onto the board then the cooler overtop? Because from what you've said, it kinda sounds like you aren't... either that or I'm being dumb. Another thing, are you tightening the screws evenly i.e in a cross pattern, and not too tight?

[m0k]

is it bent?
or does it only lift when its the last remaining screw left?

it could be because youre not tightening all four screws evenly at the same time

[A04771]

20 minutes ago, TheRandomness said:

Is there a way to have access to only that bar? Because you can just bend it back. Also, are you actually installing the backplate onto the board then the cooler overtop? Because from what you've said, it kinda sounds like you aren't... either that or I'm being dumb. Another thing, are you tightening the screws evenly i.e in a cross pattern, and not too tight?

I did all the steps you've mentioned but it didn't worked out...

I even tested to attatch the backplate and cooler  away from the motherboard if it works out. But still bad result...

[A04771]

8 minutes ago, mok said:

is it bent?
or does it only lift when its the last remaining screw left?

it could be because youre not tightening all four screws evenly at the same time

This is how the legs look like.