Concept Headphone Design

[SilicateWielder]

Mods, please move this if for some reason i'm not in the right spot.

 

Hey guys, I just made a concept design for a pair of headphones (No headband, sadly) and thought it'd share it with you, especially those of you with 3D printers. Beware though, it's not quite conventional.

 

The "Cover"

Spoiler

 

The "Panel"

Spoiler

 

[Guest]

Any commentary? What am I supposed to be looking at?

[iShad]

So is this just a housing for the drivers? What's so special about it?

[sobe]

1 minute ago, iShad said:

So is this just a housing for the drivers? What's so special about it?

 

I'm just curious why it's "not conventional"...

[SilicateWielder]

2 minutes ago, sobe said:

 

I'm just curious why it's "not conventional"...

...Maybe I was wrong then? I simply made it possible to use screws from the outside. 

 

5 minutes ago, iShad said:

So is this just a housing for the drivers? What's so special about it?

it's just housing, I thought maybe someone might be able to help critique it. I'm planning on actually print out a pair of headphones sometime and this is a design I came up with today. 

 

6 minutes ago, SSL said:

Any commentary? What am I supposed to be looking at?

There are two parts here, a base to attach your driver to, and then a cover where the headband attaches to. Forgive me if I'm using the wrong terminology here.  I haven't quite figured out how i'm going to attach a headband so i'm going with just attaching some axles to the sides, possibly securing the headband with bolts or caps that twist onto the ends of the axles. I don't quite know yet so i'm saving that part for tomorrow.

 

Forgive me if anything i'm saying is difficult to understand, i'm getting quite tired and plan/need to get going to bed after I submit this reply.