Pfsense & Intel card Need Help please

[Hijikta]

Hello everyone.
i have a problem installing pfsense on Hp pro 3500 MT (i5 3th/8Gb) and intel Quad port ET server Netword adapter
case 1 : installing Pf Without the card,everything go normal but when i add it and i start the system it stop after initiating the 1st and 2nd port (igb0 & igb1) stop at igb2 ,and i got this message :
    igb2:using MSIX interrupts with 5 vectors
    igb2:the eeprom checksum is not valid
after that i chance this file in pfsense “/boot/loader.conf” by adding “hw.pci.enable_msix=0” & “hw.pci.enable_msi=0”
after that i got the following error :
    igb2:using legacy interrupts
case 2 : installing Pf With the card,everything go normal but i can only see two interfaces “igb0 & igb1”
when i check de shell for de pci list “pciconfig -l” i got de following output
    igb0@3:00.0 and igb1@3:00.1 and none2@4:00.0 none3@4:00.1

PS: on  windows all interfaces work fine no probleme .

Now im asking the community for help, im realy stuck i dont know what to do next , im thinking to update the firmware of the card and adding driver to the kernal ,or just go the simple way and use windows 10 as server with hyper-v . 
thanks you all.

[BecauseRussia]

Sorry I can't help you with this issue specifically, but this might help.

 

I don't know if this is allowed or not, but you may find better support on forums.lawrencesystems.com

 

Tom Lawrence who runs the website has a YT channel were he goes in-depth with pfSense and other opensource projects. His forums tend to be more technical and networking based than here, so you may have better luck getting some help there.

[Hijikta]

 ah yes i know and follow him too 

thank you .

[Falconevo]

On 7/24/2021 at 3:38 PM, Hijikta said:

Hello everyone.
i have a problem installing pfsense on Hp pro 3500 MT (i5 3th/8Gb) and intel Quad port ET server Netword adapter
case 1 : installing Pf Without the card,everything go normal but when i add it and i start the system it stop after initiating the 1st and 2nd port (igb0 & igb1) stop at igb2 ,and i got this message :
    igb2:using MSIX interrupts with 5 vectors
    igb2:the eeprom checksum is not valid
after that i chance this file in pfsense “/boot/loader.conf” by adding “hw.pci.enable_msix=0” & “hw.pci.enable_msi=0”
after that i got the following error :
    igb2:using legacy interrupts
case 2 : installing Pf With the card,everything go normal but i can only see two interfaces “igb0 & igb1”
when i check de shell for de pci list “pciconfig -l” i got de following output
    igb0@3:00.0 and igb1@3:00.1 and none2@4:00.0 none3@4:00.1

PS: on  windows all interfaces work fine no probleme .

Now im asking the community for help, im realy stuck i dont know what to do next , im thinking to update the firmware of the card and adding driver to the kernal ,or just go the simple way and use windows 10 as server with hyper-v . 
thanks you all.

Last time I saw something like this it was a fake Intel network card.  Does the card have a yottamark validation sticker on it?