Phantom 820 (Radiator Thickness)

[Amer]

I was wondering if I can install a radiator on the top and on the bottom that is 80MM Thick.

Top Radiator going to be a 360MM/80MM Thick. Will it fit good without any problems?

Bottom Radiator going to be a 280MM/80MM Thick. Will it fit good without any problems?

As for the Power Hungry/Staff Hunters I know I could of put it in the Case Board but this has to do with Water Cooling so go try to post somewhere and get mod.

[BCMods]

If it's the same as the Switch 810, it'll fit.

[Amer]

If it's the same as the Switch 810, it'll fit.

It's either a yes/no answer. I don't know any other cases but this beauty one.

[BCMods]

It's either a yes/no answer. I don't know any other cases but this beauty one.

I'm 99% sure it has the same internal layout as the 810.

 

Watch TTL's review of the 820, he always mentions rad space.

[Amer]

I'm 99% sure it has the same internal layout as the 810.

 

Watch TTL's review of the 820, he always mentions rad space.

Thanks but I forgot to mention that I'm going to go for a Push/Pull configuration. But I think I can put an 45 or a 55 Thick Radiator.

[BCMods]

Thanks but I forgot to mention that I'm going to go for a Push/Pull configuration. But I think I can put an 45 or a 55 Thick Radiator.

You can fit a 60mm in the roof of an 810 in push/pull.

 

There's even more room on the floor with the drive cages removed, so I can't see it being an issue.

[Amer]

You can fit a 60mm in the roof of an 810 in push/pull.

There's even more room on the floor with the drive cages removed, so I can't see it being an issue.

But is the 820 bigger than the 810?

[BCMods]

But is the 820 bigger than the 810?

As I said before the internal layout is pretty much identical, so I would imagine the rad spacings would be the same.

 

Do you actually own the case yet?

[Amer]

As I said before the internal layout is pretty much identical, so I would imagine the rad spacings would be the same.

Do you actually own the case yet?

Yes I do. So in that case I can get a 60Mm RAD and do Pull/Push Configuration?

[BCMods]

I'm certain you can, however you could always measure it for peace of mind.

[Amer]

I'm certain you can, however you could always measure it for peace of mind.

But I watched OC3D's review on the Phantom 820 he said if you're going to go for Push/Pull you can put a 45MM...