Phanteks Eclipse P400 Front panel rgb header problem

[AKO_Tall]

Hello, i recently bought new Phanteks Eclipse P400 case, and i had quite a bit of trouble with the front panel rgb connector that shines right on the phanteks logo. From what i found on the internet, its supposed to be a JST connector of some sort, and i have no idea how to connect it to my rgb header, or whatever header it needs that i have on my motherboard. Its not that big of a deal tbh, but its still quite frustrating to me. Ill throw in a picture of it down here

[Whiro]

1 minute ago, AKO_Tall said:

Hello, i recently bought new Phanteks Eclipse P400 case, and i had quite a bit of trouble with the front panel rgb connector that shines right on the phanteks logo. From what i found on the internet, its supposed to be a JST connector of some sort, and i have no idea how to connect it to my rgb header, or whatever header it needs that i have on my motherboard. Its not that big of a deal tbh, but its still quite frustrating to me. Ill throw in a picture of it down here

If I’m correct and remember correctly (I have P400S) this connector is not for that, it may be to connect additional led strip. Not sure if the cases are same and using same controller but in my case power goes through sata cable and you changing colours using build in button 

[AKO_Tall]

On 1/9/2020 at 12:13 AM, Whiro said:

If I’m correct and remember correctly (I have P400S) this connector is not for that, it may be to connect additional led strip. Not sure if the cases are same and using same controller but in my case power goes through sata cable and you changing colours using build in button 

Weird, because i connected it to the sata power, and it doesnt light up. And when i took of the front panel that cable was directly connected to the rgb strip down below.

[Whiro]

2 hours ago, AKO_Tall said:

Weird, because i connected it to the sata power, and it doesnt light up. And when i took of the front panel that cable was directly connected to the rgb strip down below.

Hmmm did you press the button to cycle between colours ?? Button is next to reset , like slightly underneath 

[Zusafek]

On 1/8/2020 at 4:13 PM, Whiro said:

If I’m correct and remember correctly (I have P400S) this connector is not for that, it may be to connect additional led strip. Not sure if the cases are same and using same controller but in my case power goes through sata cable and you changing colours using build in button 

That cable is for the extension kit. If you get the full kit it comes with an adapter for most motherboards.