No IPv6 network acces

[Leonbl]

I want IPv6 network acces because i need it for my internet subscription to reach higher MB/s but trying to enable network access to IPv6 just wont work. i've looked up forums and videos i tried to reset IPv6 in cmd i entered the ipconfig commands aswell, update drivers, reinstall drivers, disabled IP Helper and many more but everytime it ends up in disapointment i hope someone on this forum is able to help me.

[3DDude]

Go to network and sharing center --> Network Adapters -> properties --> check before IpV6.

 

However, you will not reach higher MB/s with IPv6.

That depends on your WAN uplink; and modem you are using.

[Leonbl]

2 minutes ago, 3DDude said:

Go to network and sharing center --> Network Adapters -> properties --> check before IpV6.

 

However, you will not reach higher MB/s with IPv6.

That depends on your WAN uplink; and modem you are using.

Tried that aswell it was already checked, but then the weird part is my brother has 250 mb/s and i got 100 mb/s while we are connected to the same router with cable ofcourse. do you have any conclusion to that?

[3DDude]

Easy,

 

Your LAN port is speed 100Mbit/s
And your brothers PC has 1000MBit/s

 

So if your WAN is 250 --> your PC has only a 100 -> so you get 100 max.

 

 

[Leonbl]

1 hour ago, 3DDude said:

Easy,

 

Your LAN port is speed 100Mbit/s
And your brothers PC has 1000MBit/s

 

So if your WAN is 250 --> your PC has only a 100 -> so you get 100 max.

 

 

Is there anywhere on my PC where i can see some sort of configuration of my LAN port?

By the way i have LAN usb 3.0

Edited June 6, 2019 by Leonbl