Msi Project Zero Build Help

[KFC263]

I have a few questions about building my pc.

it is an msi m100r pz case, and project zero motherboard.

 

Partlist: https://au.pcpartpicker.com/list/CWDPJn

 

The cable in the photo is a part of the fan hub that came with the case, I’m quite sure it’s supposed to go in the jargb_v2 port (jrainbow), but it doesn’t properly sit in there and falls out with the slightest touch. 
 

The motherboard has 2 CPU power ports, am I supposed to plug both of those in to the PSU?

 

And lastly most of the cables are going to get quite bent if I put the back of the case on.

 

Sorry if this isn’t formatted well, I’m on my phone. 
Thank you in advance.

[Sant_HH]

2 hours ago, KFC263 said:

The cable in the photo is a part of the fan hub that came with the case, I’m quite sure it’s supposed to go in the jargb_v2 port (jrainbow), but it doesn’t properly sit in there and falls out with the slightest touch. 

JARGB_V2 is the correct header to plug it into. It should go in without any problem.

2 hours ago, KFC263 said:

The motherboard has 2 CPU power ports, am I supposed to plug both of those in to the PSU?

Yes, you need to plug both in.

2 hours ago, KFC263 said:

And lastly most of the cables are going to get quite bent if I put the back of the case on.

As long as everything is plugged in properly should be fine. 

[KFC263]

7 hours ago, Sant_HH said:

JARGB_V2 is the correct header to plug it into. It should go in without any problem.

Yes, you need to plug both in.

As long as everything is plugged in properly should be fine. 

IT’S IN ALL IS GOOD

 

Thank you so much for the help, yet the jargb only goes in halfway and just falls out with ease.        
 

 

Edited January 8, 2025 by KFC263