Are these temps normal

[SircarrotII]

My 12600KF maxed out at 77C on the package in cinebench R23 in a 10 minute render with all three fans and the pump on my deepcool castle 360ex rgb at 100%. The CPU pulled a maximum of 164.81 watts and 1.364 volts. The radiator is at the front in my 4000D airflow in a push config with both side panels off. The CPU idles at around 25C package temp. I used an X pattern for thermal paste and used noctua NT-H1 thermal paste. The rest of the fans in my case were around 80% and are deepcool RF120 fans. Are these temps normal and if not how can I fix them? Here is a picture of how I mounted the cooler. The brackets were interfering with the capacitors so I rotated them 90 degrees. The motherboard is a MSI Pro Z690-A DDR4. The back plate is the one that came in the box redneck engineered to support LGA1700 by using a drill and sand paper to remove the little nub in between the mounting holes so the poles that go through the MOBO can support LGA1700.

[Dukesilver27-]

It's completely fine and normal.

[SircarrotII]

22 minutes ago, Dukesilver27- said:

It's completely fine and normal.

Do you think I would be able to push 200+ watts and not throttle?

[Hinjima]

12 minutes ago, SircarrotII said:

Do you think I would be able to push 200+ watts and not throttle?

Only you can find that out.  Its not dangerous hitting thermal throttle for a bit, its just doing to downclock itself.  Give it a go!

[Dukesilver27-]

1 hour ago, SircarrotII said:

Do you think I would be able to push 200+ watts and not throttle?

Looking at the thermal performance at 165W, I think 200W will be fine.

Tho, I doubt the performance gained would be worth it, waste of electricity if you ask me.