RGB Assistance

[Maverick3324]

Hello All,

 

Full disclaimer: Total newb when it comes to RGB Lighting, so hoping to learn a bit and get some help.  I am looking for assistance with getting all of my RGB on the same page.  In a nutshell, I bought a DIYPC case that had a remote controlled fan/LED hub.  I can control fan speed, RGB lighting effects, etc. from this hub via the IR remote.  This hub DOES NOT connect to the motherboard, it is powered via MOLEX adapter to plug directly into the PSU.  Several weeks later I bought an LED graphics card support and want to connect that to the hub.  Turns out the GPU support came with 12V input and attaches to a different IR sensor. The hub does not have an input for the 12V plug-in that came with the GPU.  Currently, the two RGB effects are not synced and they operate off two different remote controls (super annoying!).  I figured their must be an adapter out there that connects 12V lightning (GPU support) to a small 4 pin LED input (on the hub) so that the GPU LEDs could run off the same hub instead of running to a whole different IR remote.  I tried the two products below and struck out.

 

Phanteks RGB LED 4 pin adapter: https://www.amazon.com/gp/product/B01BZIBJAK/ref=ppx_yo_dt_b_asin_title_o03_s00?ie=UTF8&psc=1

Barrow 12V Motherboard to Barrow RGB Adapter Cable: https://www.newegg.com/p/9SIA9F962T9740

Both 4 pin inputs for these are too big to fit in the hub that came with the PC case. 

 

So ultimately, my question is, do they make 12V to small 4 pin LED that could connect the GPU support LED to my main hub so they can all sync up? Photos/diagram of the hub and current setup are attached.  The PC case that this came with was: https://www.newegg.com/p/N82E16811353136.  Thank you in advance for your help!