redcan0

I already tried changing the order of the rams but it doesn’t change anything, its about the motherboard slots. Right now I am trying this, if this does not fix do you know any other techniques or do I have to accept the rams being not aligned?

I sticked a usb stick between the rams in the middle so that they stretch to the opposite sides. It made it a bit better but it insists on not being 100% parallel. Should I try and straighten out the slot on the motherboard?

Hey everyone, So I have this issue where when I install 4x8 ram on my B550 Carbon motherboard, the ram at the very left is further apart from others. And for some reason the 2 rams in the middle are too close to each other. Does anyone know the reason behind this and is there a fix? It bothers me a lot. Thanks.

Yeah but there was only a 100$ difference between the 5800x and 5900x I think it makes more sense in terms of value

I have 3 seperate PCIE Power Cables since my 6900 XT has 3x8 power pins. I mean I only have this issue with low demanding games on competitive settings. Games with nice graphics run just fine so I though the cpu is not good enough.

The 5800x which has 8 core seems like terrible value so I got the 5900x. But seems like it won’t make a difference so I am just going to cancel it.

Yeah I tried reinstalling drivers multiple times and power plan is high performance

No

Hey everyone, I have a RX 6900 XT and a 5600X with a 1440p monitor. In some games that use CPU a lot like Warzone, Rainbow Six Siege Competitive Settings I get low GPU utilization and low FPS. Like on all low settings, I get lower FPS than all Ultra settings which is caused by a CPU Bottleneck I think. So today I ordered a 5900X to replace my 5600X but I am not sure If I did something correct since some people told me that I will see no difference. Should I cancel my order? Thanks.

That makes sense. Ill try and lower the power a bit and see what happens then.

Hey everyone, My ASRock RX 6900 XT Phantom D arrived today. And I started overclocking it. I set the power limit to 325 watts which gave me a pretty nice headroom for overclocking. However, at this power I got a junction temp of 90-95 in 3D Mark. Whereas in stock configuration junction temp was sitting at 80-85. Will 90-95 junction temp cause an issue in the lıng term? I know AMD says up to 110 is fine and all but 95 still is very hot. Should I lower the power a little bit? I would appreciate any advice. Thanks

Hey everyone, I am planning to buy a 6900 XT but I have never used AMD in my life I always used Nvidia. So my first question is AMD is known with drivers issues are these fixed with Radeon 6000? Also I see a lot of people complaining on reddit about their 6900 XT for like FPS Drops or low GPU usage etc.. Is buying this card safe? Does anyone in this forum use a 6800/6900 XT that could share theri experiences? Should I go with Nvidia instead? Thanks.

Would it even take a year for GPU Stocks to come back? I think it would take less time than that but who knows.

The 960 is about 140$ I am going to sell the 960 anyway after I buy a proper card.

Hey everyone, I managed to buy a 3070 at MSRP a couple of months ago. Now due to the GPU stock issues someone is offering me 1700$ for my 3070. Should I sell it? And If I sell it what can I even buy right now? Looks like I cannot buy anything so I plan on getting a used GTX 960 or something for cheap. Then I am going to use it until GPU Stocks come back and finally buy a 6900 XT with the money I got from selling the 3070. But I am afraid that GPU Stocks will never come back and even if it does after a year or so. What do you guys think? Should I sell my card?

Yeah. I went with a 5600X. Thanks everyone for the advice.

I already have a 1080 Ti

The 5600X is 300$ where I live

I don't need to overclock it. However, I currently already have a 5600X and a 360mm AIO on another build and it boosts up to 4650 MHz in games. Now am I going to buy a 5600X again for my other build would it boost to 4650 MHz with the Prism as well? Do you have any idea?

I don't really plan on upgrading it. Thw whole point of me getting a Prism is brcause it looks very nice and kind of makes up for an AIO. The more expensive tower coolers look very ugly.

Will the Wraith Prism be enough for 5600x?

Hey everyone, I could etiher get a 5600x + B550-A Pro + Wraith Prism or a 10600K + Z490 Gaming X + Raijintek EOS 360mm aio? Also, the AMD option is 40$ cheaper I kind of want an AIO for looks but if its worth sacrificing for a 5600X than ill do it. The GPU is not decided yet but it will probably be a RTX 3060 or 1080 Ti Which choice above would be better for a gamer? Thanks.

Hey everyone, I am planning to buy a Corsair ICUE 4000X RGB case and a Asus TUF B450-Pro Motherboard. If I buy these two and plug in the front panel USB 2.0 cable that comes from the case for the RGB control can I control the RGB only from ICUE or is Armoury Crate supported as well? Thanks.

In Turkey there is a ton of stock for the 5600X so its not rare at all. The memory will be 3600 MHz CL14. The reason I am not sure about the Tomahawk is it doesn't have any 5V ARGB headers. The Z490 have those. I am not really sure is the 10600K that better than the 5600x?

Ill consider the 10600K for now then thanks. Also 5600x + B450 Tomahawk Max and Z490-A Pro + 10600K are the same price which combo should I pick? Both will run on a 240mm AIO as cooling. I felt like the 10600K would be better with the overclock and aio and a z490 motherboard.