-
Posts
62 -
Joined
-
Last visited
Withenex's Achievements
-
I'm not clicking that
-
-
3080 TI hitting power limit at 200w/ Not getting power from 8 pin #2
Withenex replied to Withenex's topic in Graphics Cards
I've already tried with both of the pci-e power cables on my psu. I've contacted the seller and they recommend that I submit an RMA to the manufacturer and the seller will provide me a shipping label -
3080 TI hitting power limit at 200w/ Not getting power from 8 pin #2
Withenex replied to Withenex's topic in Graphics Cards
That is definitely a possibility! If you could, do you think you could link me to some instructions on how to check/change back? -
3080 TI hitting power limit at 200w/ Not getting power from 8 pin #2
Withenex replied to Withenex's topic in Graphics Cards
I'm using the gigabyte 3080ti vision OC which only requires 2 8 pins -
3080 TI hitting power limit at 200w/ Not getting power from 8 pin #2
Withenex replied to Withenex's topic in Graphics Cards
-
I've recently bought a 3080ti and I've noticed that during benchmarks, in this case furmark my clock speeds were far below what I expected. I opened up msi afterburner and noticed that power limit was 1 and that my power draw was 200W. I thought this was strange since the TDP of the 3080 TI should be 350W. As you can see in the attached screenshot the clock speed idles at 1710 mhz but drops to around 400 during the benchmark while the memory idles at 9501 mhz and stays there. Strangely enough, at idle, the gpu sits at 1710 MHz. I have a corsair cx750 powering this rig so that should at least get it to it's rated TDP. What gives? The gpu in question is the Gigabyte 3080ti vision OC
-
I recently bought a dell r710 and I'm trying to put unraid on it. I was able to get unraid booted using the internal usb port but unraid is unable to see the 2 installed drives I put in the system. I've looked around and I've seen solutions where you have to go into PERC or the raid controller using ctrl+c or ctrl+r to configure the drives but nothing happens when I do that before the os starts. Also, I don't know if this matters, but the lights on the hard drive caddies are not turning on. They flash briefly on system boot but they don't turn on after that. I'd like to configure the array to JBOD so that unraid can handle the redundancy if possible. Thanks
-
Server came in the mail today. Is it safe to turn on?
Withenex replied to Withenex's topic in Servers, NAS, and Home Lab
The seller also gave me pictures before shipping the server https://imgur.com/a/NVtp28C To my eyes the server was adequately packaged, but it likely took a pretty bad blow to the rear. The seller is filing a claim with Fedex right now