Connor McG

As of today it has done it once, immediately after rebooting it crashed again. Any ideas?

System specs: CPU:5800x GPU:3070ti Cooler:ryou 240 PSU: EVGA 850 g5 MOBO: ROG b-550f RAM:32 gb trident z Storage: samsung 980 pro

So recently I got my hands on a 3070ti from micro center, and then I picked up an 850 g5 power supply to go along with it. I ran the 3070ti on my old 650 gq for 2 days until the new psu came in and it ran perfectly fine during that time even under load. I went to install the new psu and like a dummy didint check the cables to make sure all the pins were the same, and used the ones that were already in it from the 650w psu, so I ended up activating the short circuit protection on the psu by not using new ones. Once I replaced all the cables with the ones that came with the new psu it booted up just fine and ran perfectly even under load. Fast forward a couple days to now and in the past 24 hours the computer has just randomly shut off on me with no explanation. When I look at it I see the psu light is still on and the motherboard and water cooler lights are still on and cycling normally, but when I press the power button to start it back up it doesnt work, so i cycle the power off and on on the psu and sure enough, boots right up as if nothing happened. I have checked the reliability center and only the third time it shut off did it tell me that windows didint shut down properly. Im not sure what else could have caused this besides the accidental short circuit that was hopefully prevented by the psu, I cant come up with any other explanation for this besides the fact that I have it running on a power strip, but even then it has shut off twice not even under load. Any other ideas? Thanks in advance

Have you seated them in the correct dimm slots? try reseating them and swapping them around. Your motherboard manual should tell you which ones to put them in

UPDATE: Ok this can be closed. For some reason even though I have tried this in the past and it has never worked, setting my mic that I use as default device fixed the desktop audio problem. Hope this helps anyone with the same problem.

So I recently upgraded from my fiio e10k to a jds labs atom and topping d10s, on the fiio I could capture desktop audio with shadowplay perfectly, but now I can only capture my mic audio, does anyone have any solutions for this?

also is dp 1.4 not faster than 1.3? because your post about transmission rates shows 1.3 up to 26 gbit but it doesnt say anything about 1.4

ok, any idea about gsync?

so I got a hub that supports dp 1.4, but its only allowing two monitors at 120 hz, this doesnt make sense as dp.14 should be capeable of running them at 144 hz. im fine with the 120 but ive got a new problem, it doesnt support gsync any ideas?

cant display port 1.4 support two monitors at 1440p 144?

thanks!, anyone know anything else?

I bought three monitors( Dell S2716DG) and got two to run at 1440p144 but im encountering a problem as my gpu(rog strix gtx 1080) only has two display ports, and so my third monitor cant run gsync because its only supported on DP, and it is also locked at 60 hz when running 1440p, is there a splitter I can get that will allow me to run all three at 1440p144hz ? thanks

all it says when I download and run it is that it has a catostrophic error

I cant even open aura or uninstall it

yeah, do you know any fixes for the problems im having? my cpu is plenty powerful(ryzen 1600x)

but now im just concerned as to why it wont start

yes and the temps are fine, the cpu is never high either, so that shouldnt be the cause, whats odd is if I use the unlink button in aura for the video card they go smooth, but as soon as I use it it goes choppy

So I have been fighting with asus aura for a while now, ever since I got my gtx 1080 strix the effects are just choppy, ive uninstalled it easily 25 times and it still wont work, so I decided to update the bios(successfully) and now it wont even launch, it just says asus aura has stopped workingand then it just closes, I have no idea why and have no idea what to do, I cant find anything online that helps. any help would be much appreciated!

Also on stock ryzen master is showing this, forgot to mention, both the posts are under load

Stock AMD CPU voltages are this high, didint try to oc or anything, now after using ryzen master to oc it's still doing the same thing even tho I have a Max set to 1.3 Is something wrong here?

check my page for full build, its a 1440p 165 hz monitor with gsync

check my page for full build, its a 1440p 165 hz monitor with gsync

'

Bump, read the og post

Ive seen online alot of people able to play pubg on a gtx 1080 at ultra well above 60 fps, I barely manage 60 fps on any setting. Ive also got a problem where my web browsers wont run more than around 90 fps, and they stutter alot from 60-90ish fps. any ideas? build is in sig