Fan Controller - Finished
I've strengthened the fan controller with quite a substantial amount of epoxy glue. It might
not be the prettiest, but it won't be visible and it's pretty much bomb proof at this point.
(click image for full res)
(click image for full res)
PSU - Finished (More or Less)
There's still some very minor finishing touches to be applied, but it's as good as done.
(click image for full res)
24 Pin - Detail
There's a minor mistake in my lacing in the middle lacing section, but I'm not sure if I'm going
to redo the thing just for that. It depends on whether or not it will be visible in the final configuration
when everything is in the case. The lacing is not 100% straight at this point, that will be done
once everything is mounted, there's enough flex to do that.
(click image for full res)
Fan Cable
This cable will connect to the fan controller, hence only the 12 V wire. Obviously I couldn't
use the same technique for this as for the 24 pin.
(click image for full res)