deanfoster7828

Hello, thanks for your response. I went on amazon and had a look at some monitors. I found this one: https://www.amazon.co.uk/Samsung-LC32JG50QQUXEN-31-4-inch-WQHD-Monitor/dp/B07FJP11L2/ref=sr_1_3?crid=4FXK78DY73XA&dchild=1&keywords=1440p+144hz+32+inch+monitor&qid=1606867413&sprefix=1440p+144hz+3%2Caps%2C244&sr=8-3 Do you this monitor would be worth it? Also if there's any other ones you would recommend I would appreciate it. Thanks

Hello, thanks for your response. I was planning to get a new monitor in the near future anyways lmao. Are there any you would recommend? I had a look on amazon and found this one: https://www.amazon.co.uk/Samsung-LC32JG50QQUXEN-31-4-inch-WQHD-Monitor/dp/B07FJP11L2/ref=sr_1_3?crid=4FXK78DY73XA&dchild=1&keywords=1440p+144hz+32+inch+monitor&qid=1606867413&sprefix=1440p+144hz+3%2Caps%2C244&sr=8-3 Would appreciate your thoughts on it. Thanks

What graphics card should I get? Hello, I'm thinking about getting a new graphics card for when cyberpunk comes out. I want to run the game at 1080p ultra 75fps with raytracing/RTX on. There are quite a few new cards coming out and I'm not sure which one to go for. I was looking at picking up a 3080 when they come back into stock. Appreciate any suggestions/advice. Thanks. My specs: RTX 2060 super Ryzen 9 3900x (stock speed) 32GB 3200Mhz DDR4 Corsair Vengeance RAM Noctua NH-D15 CPU cooler B-450 Strix motherboard 1000W modular be quiet PSU 500GB SSD 2TB HDD My monitor is also 75Hz and 1080p

Hello, When I disable windows defender it automatically turns itself on after my system has been shut down. I was wondering if there's a way to stop it turning itself on so that it stays off permanently. I use a lot of mods and my anti-virus keeps deleting them upon rebooting. I know I could exclude them but I have many different mods in many different folders so disabling my AV is easiest for me. Any suggestions are much appreciated. Thanks

Yeah I had the clips on the wrong way. Thanks for your help

Hello mate, that was exactly the problem they’ve both clicked on now. Thanks for your help

Hello, I’m trying to install a NOCTUA NH-D15 into my pc. To screw it down onto my motherboard I had to remove one of the fans and I can’t get it back. I read the manual and it’s not clear what I have to do. Looking for suggestions thanks.

Ahh yeah that does make sense. Ill lower the speeds and hopefully it works, thanks. I'm looking to upgrade cpu before Christmas you think i9 9900k is a good shout?

I just tried with one stick and it booted like normal at 2133 MHz after I enabled DOCP my pc didn't boot properly and I had to change it back. Thanks for the suggestion (Also it was in slot A2)

The sticks are defiantly in the correct slots (A2 and B2) I haven't tried one at a time so ill do that now and get back to you. Thanks

Hello, I have recently upgraded from 16gb Corsair Vengeance RAM (2x8gb 3000MHz sticks) to 32gb Corsair Vengeance RAM (2x16gb 3200MHz sticks). However, the RAM sticks are only running at 2133 MHz. When I enable DOCP using the new sticks my pc doesn't boot properly and always has an error that forces me to change back to default settings. This didn't use to happen with the two 8gb sticks. I've also tried to increase the voltage but that didn't seem to help. Looking for any suggestions. Thanks Specs: CPU - Ryzen 5 2600 (stock speed and stock cooler) RAM - 2 x 16gb 3200Mhz Corsair Vengeance sticks Motherboard - ROG Strix B450-F Gaming motherboard PSU - Corsair RM850x Fully modular ATX Power Supply HDD - 2TB one SSD - 500GB one

If your still having the issue go to control panel - hardware and software - power options - select balance and then click on change plan settings - change advanced power settings - look for process power management - expand minimum processor state and set it too 100% then click apply. This fixed it for me at least!

Hello, I fixed the issue! It turns out in power management i had my cpu minimum power set to 5%. I turned it to 100% and re-ran each benchmark and now the cpus running perfectly. Thanks for the help on thermal throttling too.

Hello, I fixed the issue! It turns out in power management i had my cpu minimum power set to 5%. I turned it to 100% and re-ran each benchmark and now the cpus running perfectly. Thanks for the help.

I decided to run another benchmark on Geekbench and userbenchmark.com and my GPU and other devices got an outstanding or very good score other than my cpu which was above average. However when compared to other benchmarks people had done with the same specs my cpu is under performing by 24% (which for me is a lot) Results: UserBenchmarks: Game 81%, Desk 65%, Work 66% CPU: AMD Ryzen 5 2600 - 54.2% --- other systems were getting 78% GPU: Nvidia RTX 2060S (Super) - 95% SSD: WD Blue SN500 NVMe PCIe M.2 500GB - 167.3% HDD: Seagate Barracuda 2TB (2018) - 91.1% RAM: Unknown CMK8GX4M1D3000C16 CM4X8GD3000C16K4D 16GB - 72.7% MBD: Novatech PC-X011042