So today i changed the liquid in my custom loop, after it running for a year. While changing the fluid i switched the CPU block from a EKWB-Velocity, to a EKWB Monoblock for the Asus Hero XI. Other than that i changed the GPU from horizontal to vertical, and bend some new hardtubing ofc for the change of CPU block and GPU direction.
My GPU has a EKWB Quantum Vektor cooler on it, and its a 2080 TI, and running a i9-9900k as my cpu. However this so called upgrade ended in my cpu temps doubling, and my GPU temps going a lot up aswell, before the change my CPU was 30-50 at all time, and my GPU never above 41, even when under load, now CPU idle is 50, and GPU idle is 45. I removed most of the bubbles that was possible and in general removed as much air in the loop as possible yet i see these high temperatures, and wondering if there was any sugestions as what could cause this? And yes i do belive i applied enough theremalpaste and tightened the monoblock tight to the CPU. I changed my overclocking from 5.1GHZ off, and whent to factory settings, and yet no change in temps.
*Specs*
Asus Hero XI
I9-9900k
RTX 2080 TI Strix OC Edition
64GB Corsair 3200hz
CPU Cooler - Asus Hero XI monoblock
GPU Block - EK-Quantum Vector
EK-D5 pump/res combo
Using same liquid as before and flushed out the old liquid with destilled water, and again running EK-Blood red premix