Manuel_Antonio

Oh thanks, I was kinda worried about the fan pulling too many amps from my old dell motherboard

I had a fan with a molex connector but the connection got destroyed, and I replaced it with a regular fan connector but it only has 2 wires, the gnd and power it doesn't have the yellow nor the pwm and I was wondering if it's safe to plug it into my motherboard. Or I should find a molex and plug it into my PSU instead

Tried overvolting +.120 offset +. 72 Soc, got even worse results If i run in 4c/8t mode i get normal single score results maybe a power delivery issue with my board?

I know, but even in A320s people are gtting better scores

Im just expecting it to boost, everything it's at stock except for the ram that is running at XMP

Temps are fine, everything its at stock except from xmp thats on auto 3200mhz. it only boosts to about 3600 mhz and thats only when im gaming ( i saw videos of boosts up to 3.9) in all thread workloads is even worse sometimes i run below base clock speeds i dont know whats the problem, i have a 550W evga gold rated psu my mobo its a b450m ds3h GIGABYTE, tried clearing cmos, i updated my bios from F1, to f32 to f40 i had the same problem with all of them, games run ok just a few stutters here and there but i just want my cpu to perform like it should. Cinebench score is around 2600, most people are getting around 2900 at stock. if i overclock over 3.6 my system crashes i will attach a youtube video of ryzen master while running cinebench to see if you guys can spot anything weird other than my bad spelling also some screenshots while running aida64, thanks in advance for your replies and no, english is not my first lenguage.

Here is some data while running an stress test hope it helps

I juat noticed im getting low cinebench scores compared to reviewers im gettinf around 1150 when everyone else ia getting around 1300, i noticed my cpu was only boosting to 3.6-3.5 ghz when everyone else is boosting to 3.9, i tried OCing to solve the problem but my voltage requirements were way to high 1.35 for 3.8(i didn't even try 3.9) bc i knew it would crash, my temps at stoxk never exceeded 80° but with my dumb overclock i would thermal throttle after a few minutes in prime 95 My specs Ryzen 2600 3200 mhz thermaltake (clocked to 3000) bc i was getting better results) Stock Cooler B450M DS3H, people told me in other forums this board was bad but i dont think its the problem Rx 570 Evga 550GD