J3ff
-
Posts
11 -
Joined
-
Last visited
J3ff's Achievements
-
Is that what you needed?
-
-
yes
-
ok so i updated the chipset driver and the did the bios, no luck i was able to hit 2933 last night now i can only hit 2800, so my situation has gotten worse. and both kits still hit 3200 when i run them in duel channel
-
Ok I will do that tomorrow I have to be up at 5am and it’s almost 1am I’ll let you know when I’ve done it thanks for all your help
-
Ohhh my bad I should have known that it’s 1201
-
I’m on version 2.17.1246 So you want a pic of the dram timing control page and I’m not quite sure where to find the voltage page
-
Well it try’s to boot but fails then shows me this screen i can boot with all four sticks running at 2666 with d.o.c.p and yes the original two sticks are in slot 2&4 the new ones are in 1&3 I’m also putting a pic of the settings
-
each kit done separately at 3200
-
is this what you're looking for or should i do each kit separately
-
Hi guy’s this is my first post and I could use a little help, so I just bought 16gb of trident z rgb 3200 to pair with a kit I already had installed, now I can’t get it to boot properly at 3200 with the xmp settings the kits are the exact same just bought couple months apart. My parts asus b450f mobo ryzen 2600 32gb tridentz rgb memory 3200 all have the same timings things I’ve already done Pulled battery and cleared cmos re installed ram ran memtest86 and no problems
.png.64143524246802c620f57b2e2a56684a.png)
.png.0185196d37b5a6c6b0497b89426d3a05.png)
.png.4ea2cee0142b5a8c713c8d291acf4d5b.png)