vargadenisz

A better angle and photo of those MT214, An ex-card means its dead for good?

I did solder and tape the wires but as it turns out the solder and the tape did not held much

But if the PCB is broken then the fan wouldnt start either? Because it's plugged in into the PCB

Thank you for your time

I did not smell anything tho The thing you said could be true but i don't want to give up so easily

The wire was there, the blue one l. Wires were taped with electrical tape but it fell of from the blue one, Now i removed from all tape so i can see the connections better I sent pictures of the area but i cannot see any burn marks

The long story short (r9 290x reference) I replaced the stock cooler with my old directcu ii from a r9 280x after sanding down the parts where it needed. I had to lenghten the wires so it can reach the card's fan terminal. For the first try the card started,fan started,everything was working, i was like hell yeah, even temps were around 50C degree I tried some load on the card when a cable came loose from the lenghtened fancable and something in my pc made a quiet pop and it shut down. Pc boots and everything seems to be working exept the card. I did fix the cables and rechecked every cable and soldering but the card doesn't turn on only the fan. No signal and it doesn't heat up anymore. I checked the caps and saw nothing out of ordinary tomorrow check the card in an other pc I would like to know what parts should i check or any advice getting it working again