Graysonman

Do you have a diagram or what leads to solder?

I am trying to find some sort of case, or way I can make my galactic empire Titan light up while not installed in a pc. I could get a power supply and and jump the 24 pin connector but then I would need to get another power supply and would rather not. Does anyone have a way they can have their old gpus on display and light up or fans spinning without it being installed in a pc? I've seen some theoretical posts on it but never seen a finished product of it. Thanks!

That’s possible what I’m going to try is doing a different pump top and seeing how that affects the flow and then also try and check the cpu block and see if it’s junked you cause I reused it from another build. In regards to The pump and the flow. The outlet of the pump goes into the gpu then it goes to cpu then flow indicator then to rad and rad then back to pump

I just can never seem to get a break with water cooling. This is my 6th build and this time I can’t get the water to flow. Yes the pump is full power and been moving the case around to try and bleed bubbles. I have a flow indicator and it doesn’t show that water is flowing it is just sitting still. I have a 420mm and a 360mm rad with a gpu block and cpu block and that’s it in the loop

My water cooling layout is pump to cpu to gpu to gpu to radiator to radiator to pump top. Is this loop configured fine or what else could be causing my issue. I just had this loop in another pc case and had no issues.

Well I am lost at this point. I changed out a radiator to a known good non clogged one and still have the same issue. I also installed 2 pumps in the same loop just to see if that would help and nothing still. I have a cpu block 2 gpu blocks 2 360mm radiators installed in this thermaltake 900 case. I did make some tight bends but that shouldn’t restrict flow too much since I’m suing hardline. Should I just turn the pc on and call it a day and hope that the heat the cards make cause it to push the air and everything out?

Ya I must have a radiator clogged or something cause that pump should pump all the way through. I even added a second pump and no luck so I will be removing a radiator and testing again soon. I’ll keep y’all updated.

I’m having a issue filling this loop. I have the pump at max and have been moving the case around on different sides but no luck. I have tried using 2 different pumps. Do I need to have 2 pumps for this case since it’s so big? It’s a thermaltake tower 900. I’m using thermaltake pacific d5 pump resivoir combo currently but was using a enermax pump. I’ve power cycled and everything but no luck. I’m about tempted to just stick 2 pumps in different places to see if that works. Pictures are with the pump on. Nothing moves lol.