Brandon Preshyon

ah! okay thats where i was getting confuse so 4 of these sticks should have no issues then also they shouldn't have any issues with a 1st gen ryzen right

yes im quite aware you don't get 3200mhz just by installing it i have to enable XMP i know that

copy the model number use ctrl+f to search page and paste in the model number

its quite hard to buy a 2x16 they are never instock

just updated the topic please refresh

mate im buying 2 sets of the 3200mhz im completely replacing the 2400s

the ram i currently have are 2400mhz im upgrading to a set with 3200mhz

setup ryzen 7 1700 asus crosshair VII hero x470 16gb ddr4 g.skill trident im planning on upgrading my ram to 32gb can someone verify if 4 of these sticks will work on my board the support manual isn't clear on it https://www.amazon.ca/gp/product/B01MTDEYHU/ref=ox_sc_act_title_1?smid=A3DWYIK6Y9EEQB&psc=1 buying 2 sets of the new ram F4-3200C16D-16GTZR they are G.SKILLS

thank you fasted help i got thats all i needed to know thank you

just purchased the motherboard in the title my question is. Is the 4pin connector required for it to run either my current r7 1700 or a r7 2700x or can i just leave that one empty as from what i hear the 8pin is more than sufficent to power it

i have the same issues but happens very rarely, and i know what the issue is its the power supply which is what im replacing at the end of the month with something from seasonic this only started happening to me 5 months after making a new build with ryzen but using the same power supply i bought back in 2013

either that it might of been the fault of the socket itself on the asrock ab350m not properly clamping the cpu in place or something. regardless i do have plans on upgrading to gen2 ryzen 7 3700x and i'm not cheaping out on a motherboard this time around

or either that the stock cooler had too much preapplied thermal paste and glued it to the cpu which seem to be the case when i finally got the cpu off of it, and if you are curious yes i did apply my own paste to the cpu this time snice i know the preapplied stuff really isn't that good i used mx 4 arctic

no i didn't release the cpu tension arm i simply undone the screws and wiggled it slowly and when it finally came off the cpu came out with it so yeah i didn't release the tension arm