mikeyc332000

Cheers Paul will give it a go in the morning now CPUs ok temp wise so hopefully should be alright until the morrow Thanks for your help and tips mate they will be a great help cheers

actually mines Z87 version

Here I know the cable managements not desirable but that can be sorted after ive made sure the loops good. Just looking at this pic and inside the case I know the res is supposed to be higher than the pump but I may think that its way to far and should be closer to the pump .My only problem is as I said earlier the Rad is so huge and fat it wont sit topside with fans fitted , I have the same case as you and motherboard also if I read correctly

yes its pumping in from res then out to cpu which then goes from cpu to rad then res again making the full loop would it have been better to have fed the pump from the rad as ive seen on occasion. Unfortunately no pic at moment but will take one in about an hour as wifes out and stuck with kids hence the delay

Hi all well I will get straight to the point. I have just installed my 1st custom loop using the Phobya Pure Performance 240LT. After a lot of deliberation it seemed best to put my radiator front mounted and the Reservoir horizontal in the roof of my obsidian 450D as this way I could still utilise the 5.25 bays for Fan Control as the Rad in this kit is as wide as a bus. Anyhow I digress , my issue is that after all the stress of getting the air out of the loop and eventually getting it going all seems good except every now and then I hear a small splash inside the rad. Is this normal or is something blocking coolant from smooth transportation around the loop. Ive checked all hose connections for kinks and all looks fine so just need someone to tell me its ok or check on something I may have missed. Many Thanks